![]() ![]() Make sure that this wire is soldered on very firmly, as it tends to lose connection as the door swings open and shut. ![]() After this is complete, solder on an additional wire to attach the string of lights to the rest of the project. Next, place wire and solder all of the negatives and all of the positives together. The negative component is always shorter than its counterpart, the positive end. ![]() Next, figure out which end of the LED is positive and which is negative. To confirm that they do not touch, place hot glue to fill the holes. After this is done, spread the wires flat onto the board so that they do not touch. This step includes many complicated components and soldering steps.įirst, place the LED's into the 6 holes previously drilled. This is by far the most difficult part of our project, due to the complexity of it. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |